Command sent from CP to Control digital output of PD.
More...
#include <osdp.h>
Command sent from CP to Control digital output of PD.
- Parameters
-
output_no | 0 = First Output, 1 = Second Output, etc. |
control_code | One of the following: 0 - NOP – do not alter this output 1 - set the permanent state to OFF, abort timed operation (if any) 2 - set the permanent state to ON, abort timed operation (if any) 3 - set the permanent state to OFF, allow timed operation to complete 4 - set the permanent state to ON, allow timed operation to complete 5 - set the temporary state to ON, resume perm state on timeout 6 - set the temporary state to OFF, resume permanent state on timeout |
timer_count | Time in units of 100 ms |
◆ control_code
uint8_t osdp_cmd_output::control_code |
◆ output_no
◆ timer_count
The documentation for this struct was generated from the following file: