This is the documentation for the latest (main) development branch of Zephyr. If you are looking for the documentation of previous releases, use the drop-down menu on the left and select the desired version.

st,stm32-spi-subghz

Vendor: STMicroelectronics

Description

These nodes are “spi” bus nodes.

STM32 SUBGHZ SPI controller

Properties

Properties not inherited from the base binding file.

Name

Type

Details

use-subghzspi-nss

boolean

Control the SUBGHZPI NSS line using the PWR HAL functions. This is for
the special purpose SUBGHZSPI interface found in the STM32WL series.

This property is required.

pinctrl-0

phandles

Pin configuration for SPI signals (MISO, MOSI, SCK and optional NSS).
We expect that the phandles will reference pinctrl nodes.

For example the SPI3 would be
   <&spi3_sck_pc10 &spi3_miso_pc11 &spi3_mosi_pc12>;

Example with NSS Pin
   <&spi3_sck_pc10 &spi3_miso_pc11 &spi3_mosi_pc12 &spi3_nss_pa15>;

clock-frequency

int

Clock frequency the SPI peripheral is being driven at, in Hz.

cs-gpios

phandle-array

An array of chip select GPIOs to use. Each element
in the array specifies a GPIO. The index in the array
corresponds to the child node that the CS gpio controls.

Example:

  spi@... {
          cs-gpios = <&gpio0 23 GPIO_ACTIVE_LOW>,
                        <&gpio1 10 GPIO_ACTIVE_LOW>,
                        ...;

          spi-device@0 {
                  reg = <0>;
                  ...
          };
          spi-device@1 {
                  reg = <1>;
                  ...
          };
          ...
  };

The child node "spi-device@0" specifies a SPI device with
chip select controller gpio0, pin 23, and devicetree
GPIO flags GPIO_ACTIVE_LOW. Similarly, "spi-device@1" has CS GPIO
controller gpio1, pin 10, and flags GPIO_ACTIVE_LOW. Additional
devices can be configured in the same way.

If unsure about the flags cell, GPIO_ACTIVE_LOW is generally a safe
choice for a typical "CSn" pin. GPIO_ACTIVE_HIGH may be used if
intervening hardware inverts the signal to the peripheral device or
the line itself is active high.

If this property is not defined, no chip select GPIOs are set.
SPI controllers with dedicated CS pins do not need to define
the cs-gpios property.